ORBLVCE V-cone flowmeter 
 The ORBLVCE-V cone flowmeter / differential pressure type flow meter / orifice flowmeter unique mechanism, calculated from the design and processing ORBLVCE-V cone flowmeter, on the occasion of a measuring gas, liquid or steam applicable, with high repeatability, low linearity error, high accuracy and high measurement sensitivity technical characteristics. For small flow measurement in the production process, especially when you need precise measurements, there will be a very accurate measurement results, to facilitate precise control of the production process. Particularly suitable for large diameter pipeline application in natural gas, steam flow measurement, the smaller the repeatability error is the trade supply and demand in terms of money accounting basis of mutual trust. Use ORBLVCE-V cone flowmeter, it provides accurate and reliable measure of both supply and demand money misunderstandings and disputes can be avoided. 
 ORBLVCE-V-cone flowmeter / pressure flowmeter / orifice flowmeter performance: 
 Accuracy better than ± 0.5% of the measured flow, and their uncertainty ranges from ± 0.118% ± 0.203%, the dispersion of ± 0.55% or less; 
 (2) 10:1 above the range, and test the accuracy of on-site reproducibility, supporting the selection of high-performance differential pressure transmitter range ratio up to 20:1, with the company's flow totalizer by the amendment of the differential linear range up to 30:1, and the vibration and electromagnetic interference does not affect the meter accuracy of reproduction; 
 Repeatability better than ± 0.1%, and long-term stability; 
 Installation required by a short straight pipe do not even need the upstream requirements of 0 to 3D, the downstream requirements of 0 to 1D; do not need to be installed upstream flow regulator; 
 The pressure loss is small, has a very high measurement sensitivity (resolution), the negative pressure side pressure of 2.5 mm water column (about 25Pa) (the column height is less than the thickness of ordinary glass) can be detected. Thus in addition to the measurement of large flow to minimal flow, eg flue gas, etc. can be measured; 
 Flowmeter structural design is a fluid sweep-type structure, and thus has self-cleaning function, and therefore can not withhold any entrained air in the fluid, liquid or solid phase contaminants, ideally suited for flow measurement of dirty fluid, such as coke oven gas, wet gas, etc.; 
 No moving parts, its special design of the V-Cone can weaken the measured pressure (differential pressure) amplitude of pulsation (oscillation), thereby reducing the noise in the differential pressure signal; 
 Fluid flow through the cone with a special shape of the structure, form the edge of the edge in its throttling the formation of the boundary layer effect, thus greatly reducing the possibility of it being worn, it can be said is do not wear the type section flow of parts; production and sales of vortex flowmeters / turbine flowmeter / electromagnetic flowmeter / V-cone flowmeter 
 In addition our company also produces a diffused silicon pressure transmitter, flow totalizer, orifice flowmeter, rotameter, and other products